U2274 BMW Fault Code

Description:

Catalytic converters must be warm before they can work properly. On a cold start the PCM provides a rich mixture to keep the cold engine running.
All that extra fuel goes into the catalytic converter. But the exhaust isn't very hot, because, ah, the engine is pretty cold. GM has employed several strategies to fire up the catalytic converter quicker and reduce cold start emissions. One way is to use a secondary air pump that pumps outside air directly into the catalytic converter.

U2274 Code Symptoms :

If your vehicle failed a U2274 test and the U2274 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U2274 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing U2274

U2274 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

How to fix U2274 code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• EVAP canister or fuel tank leaks
• EVAP system hose leaking
• Variable Camshaft Timing (VCT) position circuit is open or shorted

Circuit High Input codes like U2274 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.